Last part of my puzzle....

https://www.nopistons.com/forums/upl...1056440836.jpg

installing....

Everything wired up!!

yea baby!!!!!!!!! https://www.nopistons.com/forums/pub...1047683329.gif https://www.nopistons.com/forums/pub...1047683329.gif

https://www.nopistons.com/forums/pub...DIR#>/ohmy.png oh my! https://www.nopistons.com/forums/pub...DIR#>/ohmy.png

Finally after a year plus my car is back together.... But it 3am and its pouring out, all i need to do is load my haltech map. I am going in for some dyno pulls in the next couple weeks, I already talked to the owner of Elite to make sure they could do Haltech/Rx7s. My candy has come....

Probably just an optical illusion but you may want to move the wires a little further away from the exhaust housing of the turbo. Looks like they are about 3 inches from it. Hate to see you lose all the work you just did.

The pic before it shows how far away they are, I have self vulcanized tape and other stuff to put on them..

congrats man! Can't wait to find out what that thing will do! https://www.nopistons.com/forums/pub...#>/biggrin.png

Just tossing an extra set of eyes at it for you bud, good luck

Very nice setup and very clean https://www.nopistons.com/forums/pub...IR#>/bigok.gif

I'm getting my haltech maps as we speak, but i have to figure out why my gauges are getting power 1st, they are illuminating but not turning on.... I did blow a fuse earlier... damn problems..

You might need a intercooler on that thing too. https://www.nopistons.com/forums/pub...#>/biggrin.png Congrats.Now try to keep it in one piece.Your motor look https://www.nopistons.com/forums/pub...IR#>/bling.gif

time to go lay the smack down on some cars now https://www.nopistons.com/forums/pub...IR#>/smile.png