give it to me

Carlos, you crazy s.o.b....B.J. told me you have one of everything hanging around...I guess now I believe him.

no me https://www.nopistons.com/forums/pub...1047683785.gif

if anyone deserves it , it is rotarydragon. Maybe then we can shut him up about not having a turbo

u want to sell it?

Nah, this baby is going in as soon as I get off my ass and get the necessary parts for it to install.

Nah, this baby is going in as soon as I get off my ass and get the necessary parts for it to install.[/quote]

You're making me want to make my manifold now. <_<

The problem right now is the downpipe and the BOV.



I need to make a downpipe for it. I was thinking of getting the other half of the vclap flange and clap from turbonetics, looks like the cheapest place.



Get a 3" downpipe from thurderfabrication and run a stright pipe from the turbo to the stock location of the 3"downpipe, ( cut the 3 hole flange and welded as one piece)

The only problem with this is when it come time for emmision testing i need to put back the cat, so i'll have to cut the pipe again to put my cat back on and put back the pipe as a mid pipe when done.



Had anyone used thunderfabriation. I have asked them as what type of metal is used for their downpipe and they haven't been specific with the metal type or number. I want something thick like racing beat downpipes, that will out-last the car.





The other problem is reusing my apex bov, i have the kit not the universal kit on my car. I need to get a aluminun flange for it but apex doesnt sell it by itself. I think may have to try to make one or get a new cheap bov.



C

Nice, what size is that?



Maybe I should go check my basement...there may be a '93 R1 w/ single T88 upgrade and bridgeport layin around https://www.nopistons.com/forums/pub...>/rolleyes.gif