ok the on the fc what does the water temp switch do? it that little thing on top of the thremostat housing. if it doesnt read temp and its not for the gauge so what the hell does it switch or do? tyvm in advance

-James nj

im pretty sure the switch your talkin about it the switch that turns on at what temp your FANS start going on. https://www.nopistons.com/forums/pub...IR#>/smile.gif

dude tyvm i no longer use the stock thermal fan so i guess i no longer have to have it connected if any one need a stock tII fan i have 2 both of them work.

the stock fan doesnt need a switch, its not electric. it works on a coil of wire growing and shrinking to decide how tight it is on the shaft to determine at what ratio it spins to the rpm of the e-shaft pulley.



kevin.

so wtf does the switch do i hope its not that important

you are incorrect. FD's fans ARE ELECTRIC, i have one https://www.nopistons.com/forums/pub...IR#>/boink.gif

you are referring to older rx7s only https://www.nopistons.com/forums/pub...IR#>/smile.gif

which i also own (1g and 2g)

Yeah, because this isn't the 2nd Gen section or anything.

uhm but it is an rx7 forum and which is also on the internet are on the internet so it must be true if you read it and everyone is always right.

its for the second gen duh but anyway i went through the haynes manual and found out there is (well used to be) a small efan in front of the radiator witch uses the switch to turn it on. i think its a seconday cooling fan and also for the ac condensor fan but yeah i dont need the connection for it b/c i removed the a/c system and put a koyo rad with the fiero e fan witch is plenty of cooling. any way thanx for your guys help merry xmas

-James

i TOLD you bitchez https://www.nopistons.com/forums/pub...doublebird.gif