The spring loaded device bolted to 2nd part of intake manifoldd that goes to the air pump is the EGR right?? and to remove egr and air pump all i need is block off plate??

the egr is bolted to the rear of the intake manifold in a t2. you're thinking of the air control valve



mike

can i take that off if i take the air pump off??

yup



mike

do i just plug up the vacuum lines and put a block off plate where ACV was?

and what about the electronics attached?

Just buy the block off plate. Pull off the ACV/air pump. Unplug the 2 (i think) plugs. Cap off/plug the vac lines. Install the block off plate, be sure to use some RTV. https://www.nopistons.com/forums/pub...#>/biggrin.png

so the plugs dont have to be plugged up?

the electrical ones dont need to be hooked up to anything



mike

cool