I need the specs for some bolts to block off the ps line holes in the rack. I threw my lines away so i cant use them to get the thread size https://www.nopistons.com/forums/pub...1047683664.gif



I also need the thread spec for the starter bolt that goes into the bell housing, the shorter one, not the long one with the nut on the end. Mine snapped in the tranny, so i need to drill and re-tap.



BTW, the dealer was NO help for any of this and there was nothing of the sort in the FSM



thanks in advance

I have no idea what the tread pitches are, but your best option would be to goto lowes or home depot and buy every single metric bolt they have (they are like 10 cents each) take them home and see which ones fit. Ofcourse you would remember to mark each bolt and their thread pitch ebfore leaving so you have a way to tell later.

1.5 mm thread pitch is common. https://www.nopistons.com/forums/pub...IR#>/smile.png

Cant remember exactly but I believe it was either 10-3 or 10-8 unless I am completely nuts which may be tghe case since its 2AM and Wed

https://www.nopistons.com/forums/ind...howtopic=25121



just buy some new bolts, less hassle....

I am going junkyarding today so hopefully I can find some starter bolts.