Do both of these recieve power or just one?

got it, closest is 12v, the other is grounded....

The one with the white band is 12+

So in my pic, the side with the band gets the 12v, what does the other side get? The other bolt has a wire going to it? What is that for?

Guys at the club said ignition switch

I would have to ring it out to be positive.

I just looked at my connectors from my main relay box 'diagram above' Man, those are loose as ****...



One was totally Dirty, and the positive lead was loose. i wiggled it a bit and it fell out of it's connector. WTF!



I guess those are important right? https://www.nopistons.com/forums/pub...DIR#>/ohmy.png

Its suppose to be the wire coming from the ignition. Now everything works, but my starter turns on whenever the car recieves power... Is there suppose to be a relay wired in? I have a power wire going the nut, and the wire coming from the ignition going to the clip-prong....





https://www.nopistons.com/forums/pub...1047683561.gif

Still confused.... It appears I have it wired right? https://www.nopistons.com/forums/pub...1047683561.gif

beats me man i havent gotten this far in my swap yet.

Well you might not have to do, I moved my battery to the back of my car, and weeded out the chassis wiring so I am redoing a lot of from scratch.... https://www.nopistons.com/forums/pub...IR#>/wacko.png

do you have power at the clip, all the time? that little wire is what turns the starter on, it should only have power in start position



mike

do you have power at the clip, all the time? that little wire is what turns the starter on, it should only have power in start position



mike [/quote]

It has power when i turn the car to accessory...

Well I finally cleaned up all the loose wires and I did some investigation. After cleaning up all the gas that spray on my car https://www.nopistons.com/forums/pub...1047683358.gif I found out that no wires have pwr @ the start position except the single wire on the ignition, which has power @ access/on/start, some other wires in the loom have power @ on and some @ on & accessory. So is there a relay for the starter?

theres that switch, ah is your wire black with a green tracer?



mike

When shrunk you cannot read the fine print. Anyhow yea mike there is a switch I must be missing.... thxs for all the help!

Well I looked at the real wiring diagram of the ignition switch and it has 5 wires, I just must have thew wrong one...