ok i change my back breaks yesterday and then i changed mt master cyclender today and my breaks still goes to the floor and yes i also blead the breaks to. need help

did u bleed the master cylinder be fore u put it in the car? it needs to be bench bled

Since is too let to bench bled...



Either let the master cylinder leak a little (all 3 lines one at a time) and bleed there and/or bleed the rear brake at the banjo fitting. A lot of air collects there, you'll hear the air come out as you squeeze the brake then close. Then do the fronts in case you got air in them too. Start with the furthest wheel away from the master cylinder and work you way up.



You'll need help and try not to get brake fluid on the paint.

ok thanks everyone i am going to go try that when i get home and see what happens