can somone tell me where there the relay for the drive side blinker?

if the unit is not working, either the bulb is out, or the wiring has broken to that specific light, there are no individual relays for blinkers

ok the the driver side blinkers, front and back dont work y

Check bulbs

check the wiring at the bottom of the colum first, make sure the turn signal wires are all good and tight in their connector, then if that works. Check the wires out of the switch using the factory service manual for guidance and check for power at the turn signal connection harness on the right side wires. if there is power there, check the bulbs

the cpu has a flasher unit in it, but bulbs first

thats the only difference from the cookie cutter domestics really..



this is simple stuff.. hardly worthy of a thread..

What about dirty injectors, are they worth a thread? Or 2? Or 7?



OHHH SLAM DRAMON

i forgot to say thay dot do **** thay light up or nothing

bulbs first

sorry about the speeling all little druck lol

Use a test light and see if there's power coming to the blinkers at all



Redwood

check the fuse panel in the footwell. I had a similar problem, but both sides didn't work. Does the turn signal and high beam cpu still click?? check the female prongs on the fuse, sometimes they separate over time and don't connect properly.

cpu?

how do i get the picture on the left?

in the footwell, right above the fuse panel, there is a small black box..that's the cpu, you should here it click if it's working properly, if not, that could be the problem

go to your personal setting and upload or set an avatar