https://www.nopistons.com/forums/pub...#>/biggrin.png

If all goes well Saturday I will get some Baseline numbers on the following Set-up:



https://www.nopistons.com/forums/pub...1047683894.gif https://www.nopistons.com/forums/pub...IR#>/bigok.gif NEW Pineapple Engine https://www.nopistons.com/forums/pub...1047683894.gif

Stock ECU

Stock Intake

Deleted Rats nest

Pineapple Sleeves

Stock , with gutted cats, exhaust





https://www.nopistons.com/forums/pub...IR#>/bigok.gif After we obtain those numbers the Microtech LTX-8 will be installed and tuned, then in the future a return visit to the SAME dyno will occur.



https://www.nopistons.com/forums/pub...IR#>/boink.gif After that, the RB Road RAce Header and UBER NICE Collector and exhaust will be tested.





I hope this Staged testing of mods will give me a better idea of the mods potentials.



Stay tuned!!!

you arne't going to break the engine in?

sweet, are ya gonna tune this setup on the dyno?



mike

Just got a new Pineapple engine? Sweet... I should be getting mine for the TII in two or three weeks, lol. https://www.nopistons.com/forums/pub...DIR#>/wink.png

i'd be curious to see what kinda numbers come outa that

Thats awesome, finally get to see some hardcore #s on products. Very cool! https://www.nopistons.com/forums/pub...IR#>/bigok.gif

Nice....having a run for each set of mods is such a good idea.

This is just a "quickie" dyno pull. Its during a group thing so not a lot of time for tuning.

since I have to go to Atlanta or Charlotte for a Decent Dyno operator, I am going to do quckies on Batlgrounds Dyno and Dynolab in Atl this weekend

nice

Who's tuning ur Microtech for u????



I also noticed u chose the LTX version...did you go w/ the bosch coils??

i wouldn't even know where a local dyno is

Pineapple Stage II

9.5lb RB flywheel

Stock ECU

Stock Exhaust, gutted cats

TB modded by removing plates

No Emissions

Evans NPG+

Pineapple Sleeves

Cleaned and Tested Fuel Injectors (by Marren Fuel Inj)





108 HP/107 Ft-lb torque.....

It appears that the 6 ports are not opening/operating properly. Think is a DOG to REV.



Another Problem is the 3.9 Non-LSD rear-end.



Will troubleshoot the 6-ports sunday. Since I am installing the LTX-8 soon I will go ahead and wire the RPM switch up with an Electric Airpump to actuate the 6-ports. Updates to follow. A very frustrated Banzai

https://www.nopistons.com/forums/pub...O_DIR#>/11.gif Can you try tieing them open? Has this fresh motor built all its compression yet?

is that pretty much asking if its broken in yet?

Basically...

then building compression is just a little bit of breaking in a motor?

I applaud your efforts and results will come. Hope to see you on the 6th and your welcome to review how I have my 6 ports set-up to give you some ideas and also help me verify that that and the VDI is working properly. Keep up the good work!



Ken

Well as I suspected the 6 ports aren't working correctly. I am going to actuate with an electric airpump

Hope you get some good results.

6 ports are an n/a thing