Crossmember Measurements?
#1
I'm new to RX7s myself, and although I don't own an rx7, I do have a rather interesting project in mind right now. What's the width, end to end, on the FC front crossmember? And is it bolted to the frame rails, or welded? (ie. can it be easily removed?). If everything lines up, I should be able to transplant the crossmember as an engine support unit with minor hacks into the donor car.
Thanks!
Thanks!
#3
a series 4 turbo into a 240z - if I can just hack up a stock crossmember (no need to use the control arm points), I can use that for support (plus it'll be a hell of a chassis stiffener up front).
Thanks for the help!
Thanks for the help!
#5
the stock motor is set far forward - a 13b would make the car a mid-engined vehicle, actually. I've thought of remaking stock mounts - but htat would put the motor too high and far forward. I'd prefer to go with lower center of gravity and more rearward placement.
#9
dude...what about an RB26dett swap?...its a nissan/datsun motor
or a 2 liter turbo 4cyl? (sr20det?)
the 13b swap would be cool though
Thread
Thread Starter
Forum
Replies
Last Post
Cheers!
Rotary Engine Building, Porting & Swaps
31
02-18-2007 12:09 AM
1Revvin7
RX-7 & RX-8 Parts For Sale & Wanted
1
12-25-2002 08:37 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)