HEY GUYS ANYONE KNOW ANY GOOD BLOW OFF VALVES THAT SOUND GOOD FOR MY 87 TURBOll WITH A 89-91 S5 TURBO , I'M LOOKING FOR THE LOWEST PRICE , I WANT TO REPLACE THE ORIGINAL ONE I DON'T WANT TO TAKE A CHANCE IT MAY NOT WORK RIGHT AND HURT MY NEW MOTOR AND TURBO . PLZ ANY FEED BACK IS HELPFULL

the stock one is good https://www.nopistons.com/forums/pub...#>/biggrin.png , if you gotta have one, get one that plumbs back into the intake, the ecu gets confused if you dont



mike

you can always turn your stock one around to face the firewall...much louder https://www.nopistons.com/forums/pub...IR#>/smile.png



Its hard to find exact replacement kits though for stock mounted intercoolers on FCs....you can try ebay...sometimes somebody has one welded up that would work...

bad pic but you get the idea



http://bling.imperial.org/ProjectTII/turbosetup.JPG



it'd be easier to understand what's going on if that was all on the motor and not the work bench



btw it's the GReddy Type S w/ FC flange thingy type yea hehe

which causes you to run rich between shifts. but i like the blitz bov for the TIIs they fit perfect and no welding. they go for about 150 on ebay, but if you want a loud ass mofo get a turbosmart. they run about 250 or so and have to be welded but they are loud as ****. it will scare the hell out of people. they will think you have a really big turbo. lol.



TurboSmoke

i see a HKS filter and nice greddy bov i like that. is it loud or no?

nice setup blink, did you make that Tid?

I wish I knew if it was loud or not but I really haven't seen much boost since I've been breaking in a new motor https://www.nopistons.com/forums/pub...IR#>/smile.png



Revvin - yes & no. I went to an exhaust place and they bent me a 43 degree bend in 3" piping. Which then I cut down to fit. The silicon couplers are from XS 2.75" -> 3 (note i have an upgraded turbo so don't go order this size for a stock turbo) and 3" - 3". I haven't tested it out since I'm just putting the car back together now but it should work good total cost i'd say is.. 5 bucks for the pipe.. 28 bucks for the silicon couplers and then I had the hose nipples so that was a previous cost https://www.nopistons.com/forums/pub...IR#>/smile.png

I wanna see a pic of it all installed https://www.nopistons.com/forums/pub...IR#>/smile.png

well when the new motor is done being broken in let us know how it sounds



TurboSmoke