NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   Alive (https://www.nopistons.com/2nd-generation-specific-17/alive-75601/)

rtrypwr98 06-18-2011 09:25 AM

Well it's a success.... After 3 years and a lot of headache. The Turbo II is alive. Major problem turned out to be the ECU was the issue with fuel. The car now has tons of power and has no problem breaking the tires loose in first gear at 7k rpms. That's not a clutch dump, that's under power going about 30mph. Now my only concerns are the coolant leaking from somewhere, and oil cooler leak and the alternator belt that keeps shredding. So my first question is does someone have a dual pulley for an alternator that they are looking to part with?

RicerJ 06-18-2011 09:04 PM

first the oil cooler leak might just be the lines which are made out of cloth and tend to leak like a bitch after they have been leaking for a week so replace those with ss braided lines the coolant leak might be the hoses or a drain plug as for the alt belt keeps shredding idk what can cause that

rtrypwr98 06-19-2011 09:17 AM

I've read that when the air pump is removed there isn't enough tension from the alternator and the belt will burn up. So I guess a dual belt pulley on the alternator will give the tension required. The oil cooler is leaking bad...you're right probably the lines. They were pretty oily when I put the thing on but was more worried about it running. The Thermostat neck on the block is plastic and had a crack in it. I put some plastic weld on it to tide it over till I could get it running good enough to find all the leaks.....I couldn't even get to operating temp without a foot on the gas so kinda hard to be in 2 places at once. Will replace with a stainless one soon but the buzzer keeps coming on for low coolant and I have to add just a small amount. Dont see any puddles and don't smell from exhaust. Ever had problems with air bubbles in the system?

RicerJ 06-19-2011 01:16 PM

Is it s4 or s5 from the plastic neck part im guessing s5 and i think its mazdatrix that sells an aluminum replacement for it but as far as air in the system just bleed it normally then run it a bit with the cap on but not tight and the neck might still give you problems by letting in air so replace it and you might have a shot at getting no air in the system

rtrypwr98 06-19-2011 08:58 PM

AHHHH yes. Good call. I didn't think about it letting air in just thought about it leaking out. Hmmm. Will get that coming as well right away. I'm not so concerned about the oil leak as that damn loud Low coolant buzzer that makes my head hurt. Thanks for the advice

RicerJ 06-19-2011 11:07 PM

no prob but you will want the oil leak fixed before you drive it hard also carry oil with you if you dont plan on fixing it right now

rtrypwr98 06-21-2011 04:14 AM

It seems with rotaries I will want to keep a quart of oil with me anyways right? I'm planning to fix all the problems soon. I've been sitting on this car for 3 years to finally get it running I don't want to screw it up :-P Will post some pics soon now that I can say I have a 7 not just a nice looking flower planter.

RicerJ 06-21-2011 04:40 AM

Lol i have figured with my na i dont need to carry oil if i do my regular maintenace on it i dont burn much so its safe range

j5sense 06-22-2011 01:34 AM

wow i just posted on your other post from the 1st. So what fixed it? did you replace the pcm or was it the fuel?



please let me know asap as I have the SAME problem with my turbo II

RicerJ 06-22-2011 01:49 AM

there is a bit of difference between s4 and s5 t2's so you might get it fixed by the same way or you might not dont count on it just make your thread and explain what you have done to it whats going on and if there is anything to check


All times are GMT -5. The time now is 04:13 AM.


© 2024 MH Sub I, LLC dba Internet Brands