How do you do it ? What will I need? thanx my bad for repost

You'll need the 5-lug hubs, and if you do the 4-piston brake calipers (why swap to single, that sucks!), the brake lines from the calipers, the booster and proportioning valve from the donor car.



Remove the axle nuts on the rear, remove the single shock nut on the rear, and I think 2 other bolts that hold the rear hub to the control arm. You may have to use a gear puller to get the hub off the axle. Also remove the brake line (flared-nut wrench), and e-brake cable.



The front, remove the 2 bolts that hold the hub to the shock, the pinch bolt for the ball joint, the cotter pin/castle nut for the steering arm thingy, and I think maybe 1 other bolt that holds the hub to the control arm. Also remove the brake line (flared-nut wrench).



Booster is easy to replace, I think it's 4 bolts, remove the nuts inside the cabin above the pedals. 2 bolts hold the master cylinder to the booster. The proportioning valve is held in place just by all the brake lines, I think. Bleed the master cylinder, bleed all the brake lines, check to be sure you have good brake pads, smooth rotors, good bearings (mine were bad on the donor pieces), and I think that's it.



I'm sure I missed something somewhere, someone help me out.

I have the parts available if you need them

banzai=good seller





If you're one of those "do what I can while I'm there" people, you might want to look into an LSD, the rear-steer eliminating bushings, and maybe all the other bushings as well. You could remove the entire rear subframe, and get everything done at once.

whats the difference i was told if i had a 4 lug to run away. I thought it would be maybe a different suspension but according to the parts ou listed it looks like brakes and the hubs so what is the point?

can you put the 4 piston calipers on the 4 lug rotors?

I think more people do the 5-lug conversion cause you can find more rims with 5 lug patterns. Blah, not worth the hassle. Just slap on a LSD on there off a TII or GTU, replace the bushings, and replace struts and springs and call it a day.



I don't know if there is an advantage of changing out the single piston brakes to 4 piston brakes? Prove me wrong.

I would say this is the main reason for the change, along with the vented rear rotors. Plus I got all the parts real cheap. https://www.nopistons.com/forums/pub...IR#>/bigok.gif