I just got my car back together and my 12v ign wire that i tapped doesn't seem to be working or the starter is killing it.



With the key in the 'on' position i have a 12v current... as soon as it goes to start the 12v current disappears.. back to the on position and i have my 12v...



basically my car can't start because i'm shutting the power off to my microtech when it's starting... help? https://www.nopistons.com/forums/pub...#>/biggrin.png



The car is back together bare block, TB mod, and microtech installed. just doesn't run.. and i have all these extra bolts... hrmmm https://www.nopistons.com/forums/pub...#>/biggrin.png

Well pull out the multi-meter and check a whole bunch of areas, there should be atleast 1 on the dash harness( that plugged into the old ecu), one on the radio, several near the fuse box, and ofcourse you could use the ignition key. Hope you get that started!!! I know how that **** feels, all that work and hey wtf?

i had that same problem, just look for another wire down there, there are a couple



mike