Hey all,



I just purchased a 20b engine that I plan on putting into my '85 GSL-SE. I was wondering if anyone here has done this. The engine I bought comes with: transmission (I don't plan on using it), both turbos, intercooler, wireing harness, and ecu, coils, and extras (alternator, ac pump, ect.). I think that the engine is supposed to mate up with my transmission, and that I will need to modify the motor mounts.



Any and all suggestions will be greatly appreciated.



Thanks,

Larry

Well the tranny will mount up but youll need a new flywheel plus i dont think the tranny from your gsl-se will hold up to the power of a 20b. You will defintly have to make some custom motor mounts for it.

i've seen a couple pictures from japan, but there arent any here i dont think.



mike

Has anyone done this before??



Larry

jesus padilla has a n/a 20B in his first gen https://www.nopistons.com/forums/pub...DIR#>/wink.png

Vosko,



I jesus Padilla in the TRI State RX-7 club also?



Larry

yes he does have a 3 rotor FB. https://www.nopistons.com/forums/pub...#>/biggrin.png

https://www.nopistons.com/forums/upl...1034848494.jpg

https://www.nopistons.com/forums/upl...1034848551.jpg

You mean this 20B FB from japan?Look how tight its sit all motor.Even moved the rad right up front.http://homepage3.nifty.com/ssafcd/st...g/P6300031.jpg