Carbing A Gsl-se 13b
#1
Senior Member
Thread Starter
Join Date: Mar 2003
Location: from spokane, now a west sider...
Posts: 422
Hey, ive got a good gsl-se motor laying my my mom garage, i am seriously thinking about carbing it and putting it in my 81 rex...
are there any simple ways to do this.. ive heard of problems because it is a 6 port engine..
any suggestions?
thanks
-greg
are there any simple ways to do this.. ive heard of problems because it is a 6 port engine..
any suggestions?
thanks
-greg
#4
Originally Posted by gregs' date='Oct 5 2003, 08:50 PM
i was thinking about using a stock 12a nikki carb, but i heard they dont flow enough for the 13b.. what kind of setup would you guys reccomend?
-greg
-greg
#6
Senior Member
Thread Starter
Join Date: Mar 2003
Location: from spokane, now a west sider...
Posts: 422
#7
I just got my 86 six port with racing beat intake/holley. finally got it running right, the four barrel opening. It is crazy fast. First gear is non exsistant, just buries the tach after 3 grand, its great. Lots faster than my 12a and pulls so hard up top. I love it, I am so glad I did this.
#8
I myself am kinda anti fuel injection just becouse the stuff drives me crazy!!!
check out mazdatrix they have all sorts of fun stuff go to racing only section, there you will find what you need, they have 3 choices weber down draft and side draft
setups and a holly setup.... good luck!
check out mazdatrix they have all sorts of fun stuff go to racing only section, there you will find what you need, they have 3 choices weber down draft and side draft
setups and a holly setup.... good luck!
#9
go with a holley 600 or 650, anything bigger with would be useless...since u have a six port motor.. a racing beat six port intake manifold, get a nice header, if youre rebuilding i wouldve advisied u to lose to six ports.. and get t2 4 port side housings... 4 port is better than 6 port in my opinion... for porting and power making..
i use to have a 12a bridge port holley 650 racing beat intake manifold header and cat back doing 13.6's with stock tires a stock 3.90 diff and a 4 puck act clutch...
i use to have a 12a bridge port holley 650 racing beat intake manifold header and cat back doing 13.6's with stock tires a stock 3.90 diff and a 4 puck act clutch...
Thread
Thread Starter
Forum
Replies
Last Post
Rxcalibur
1st Generation Specific
16
05-17-2005 05:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)