whats up, where does the single wire come from off the starter?? i was messing around with the wiring harness cleaning up the emissions and i seem to either cut it on accident or removed it https://www.nopistons.com/forums/pub...1047683358.gif ... thanks alot

1 wire the thik one is coming from the battery and the small one goind to the selenoid is form the ingnition swich

black with a white stripe right??

i dont know what color bout if u haave a test ligth u can find out u aneed a friend to help u

tell u friend to crank the ingnition swich if its getting power and closing it when he releases the swich is the rigth one if not keep checking

have you got all the wiring diagrams?

no, no wiring diagrams and i blew a fuse on the fuse box thingy, so i have no power to the car, either way the engine is stripped

i think its black with green, but i'm not sure.

can anyone confirm the color?? and any other helpful information...



doesnt it come from the wiring harness next the the steering box??

it does come from the harness by the steering box. it goes from the starter to the start terminal of the ignition switch

There should be a direct conection from the battery to the starter. There also should be a Black wire with a Yellow stripe going to start terminal in your ignition switch. some also have a Blue wire with a White strip that goes to the Hot Start Relay I think.....

alright alright, i think i got it now, i looked at the harness i fooked up and theres like three of the same wires coming out of 1 slot on the connecter head (black with yellow stripes) doesnt matter witch one i use?? i also tried looking for the wiring diagrams on ebay for cheap but they dont have any



thanks

its black with white

Is it ok to scan a wiring diagram and post it on the thread???

yes, of course

I've attached the engine electrical chapter of the 2nd gen workshop manual, it may be of assistance to you.

https://www.nopistons.com/forums/pub...DIR#>/wink.png

If I can find my 1st gen workshop manuals, I'll post that one up too.

grrrr... i found the wire that i cut on accident, but i cant see to find were it came from... i tried the wires from the steering box harness, but i cant see to find it.. if anyone can scan the wiring diagrams for me, that would help me alot!!!



thanks again

Here ya go... hope it helps! https://www.nopistons.com/forums/pub...IR#>/smile.png

thats like reading alien code

Well if ya look you can find the battery, Starter, Ignition switch etc..... The lines coming off the componets are wires and you can identify them by color code next to them i.e. BY, LW.......



CODE:

B=Black

Br=Brown

G=Green

Gy=Grey

L=Blue

Lb=Light Blue

Lg=Light Green

O=Orange

R=Red

W=White

Y=Yellow



Once you find the starter on the diagram you can see 4 wires coming from it. one going to the battery. One going to the fusible link then to the hot start relay LW (Blue-White). One going to the ignition switch BY (Black-Yellow). The ground (It touching the tranny), And then there is a Black with white strip wire going to a inhibitor switch, But only on automatics.... Hope this helps.......

ya im automatic,,, wheres the inhibitor switch??

Having never seen an automatic RX-7 up close, I'd say either on your transmission or shifter.

it just goes inbetween the key and the starter, when its not in P or N it wont let you start it

thanks

sorry its been awhile, ive had many other things going on but basically i have pictures of where i believe the starter wire is now... these pictures show the wiring harness coming from the drivers side...



http://img155.imageshack.us/img155/989/dsc000309cx.jpg



wiring harness



http://img155.imageshack.us/img155/3508/dsc000313ek.jpg



then this is what it runs too, i believe i have the right wire, it comes froms the plug with three wires running to the same connector...



any insight?

anyone

.

please?!?!