I am going to put a mallory fuel pump on my weber 12a setup and I am putting a fram hpg1 fuel filter in there somewhere... I was talking to my friend and he said I should run it like this...
Tank----Fram filter-----Mallory pump-----Mallory pres regulator--- weber but I though you were supposed to run it like this Tank----Mallory pump-----Fram Filter-----Mallory pres regulator-----weber correct me if I am wrong but don't you want the filter to be pressurized? hooking it up his way will make the pump work a lot harder will it not? What do you guys think? -C- https://www.nopistons.com/forums/pub...1047683664.gif |
You don't want the bad stuff going into your Fuel Pump.
Tank-Fram G-12 Filter, At the Fuel Oulet line i.e. Firewall another Fuel Filter either Fram Filter or a See Threw Glass Filter before Regulater and your set. If you don't use a filter before the Fuel Pump, any Junk i.e. rust will screw up your Pump in the Future. Good Luck steve sgieldon |
Originally Posted by sgieldon' date='Mar 28 2003, 08:02 AM
You don't want the bad stuff going into your Fuel Pump.
Tank-Fram G-12 Filter, At the Fuel Oulet line i.e. Firewall another Fuel Filter either Fram Filter or a See Threw Glass Filter before Regulater and your set. If you don't use a filter before the Fuel Pump, any Junk i.e. rust will screw up your Pump in the Future. Good Luck steve sgieldon Raul |
Isn't there a strainer inside the tank? There is on my -se tank, can't remember with the 12a tank. But anyways you should have a strainer before the pump and a filter after the pump.
|
two filters seems a little over cautious to me... The gas tank has been empied and cleaned and I want the least amount of restriction on the fuel line itself...
so just one filter after the tank is probably best right? -c- https://www.nopistons.com/forums/pub...1047683473.gif |
If you installed a Reg before the Carb and after the last filter in the line, you will know if there is any restriction and can be adjusted accordingly.
Granted that your line is clean to start with. steve https://www.nopistons.com/forums/pub...#>/BURNOUT.gif |
Originally Posted by Zalaj' date='Mar 29 2003, 04:56 AM
so just one filter after the tank is probably best right?
-c- https://www.nopistons.com/forums/pub...1047683473.gif |
filter before pump. I am running a Mallory fuel pump with Mikuni side drafts. No problems in 5 years.
|
All times are GMT -5. The time now is 09:04 AM. |
© 2024 MH Sub I, LLC dba Internet Brands