i can almost fit my foot and leg all the way through my muffler.



3" inlet, 3" core, 4" tip. chrome. yum.



can anyone tell i'm getting antsy to finish this DAMNED project?????

yah, hurry up!

I've got one of those on order too.3" exhaust on a T2 setup.Heavenly noise. https://www.nopistons.com/forums/pub...#>/biggrin.png

You're getting antsy? My car has been taken apart for the past 6 months. Robert has taken WAY too long to get me my parts. I'm still waiting for him to send me the fuel pump and pressure regulator, that I paid for close to 6 months ago. It'll be worth it when it's done, but I'm wishing now that I had spent some extra $$ and bought the parts form someone else.

Juniors.I bought the car dead.It was sititng for god knows how many years before I got it.Its been dead in my driveway for 6 months.On the plus side my new trailing coil should be here soon.The heavenly music will start one day in the near future.If I can escape work to get to the damn car. https://www.nopistons.com/forums/pub...DIR#>/wink.png

Hmm maybe you could show us some pix's when your done?

Here's some pics of my 1/2 finished 12aT to hold you over until ioTus gets some pics https://www.nopistons.com/forums/pub...IR#>/smile.png



http://www.cardomain.com/id/coldy13

If the weather stops raining I'll post some new pics of my engine bay. https://www.nopistons.com/forums/pub...#>/biggrin.png

coldy13 you still havent taken closeups of your boost guage and explained to me how you did it. care to PM me or just post here??

http://images.cardomain.com/member_i...921_9_full.jpg



It is VERY easy to add the boost gauge there. Take off the center console and remove the clock. The hole where the clock was needs to be expanded a little bit. Take a dremel, pick whichever cutting tool you want, and grind out the hole in the console a little bit at a time until the boost gauge fits into it. Then I cut off the wiring clip from the clock and attached those wires to the light on the boost gauge. To attatch the gauge to the console, I just used a bunch of hot-glue on the back-side of the console, it seems like it's attached on there plenty good. To get the vacuume line there, I used a small hole in the very back of the passenger's footwell. It is covered up slightly by the carpet, and has a rubber plug in it. Then just put the console back on just like you normally would. It you wan't any other pictures just tell me what exactly you want the picture of. I can take them tomorrow, but my car isn't in my garage tonight and my camera takes very shitty pics in the dark.