https://www.nopistons.com/forums/pub...1047683473.gif I have an 84 rx7 with a 12a. I took a trip to a salvage yard. I find a 1980s gslse with the 13b and the four wheel disks. and the limeted slip rearend. I'm buying for 300 hoping the seals are still good. I want to know how difficult the motor swop is going to be. I swaped motors in this car before but it's all been 12a motors.
|
if you have the whole gsl-se its super easy, just put the whole set up on your car, its a 100% bolt in
mike |
Like mike said.Super easy.
|
One thing they didn't tell you is that you WILL need to swap the K-member from the -SE into the 12a car for it the motor to fit. OR you can keep the 12a K-member and purchase the Racing Beat cross mount that allows for the installation of a 13b into the 12a chassis.
The reason you need to do one or the other of the for-mentioned is due to that fact that 13b is 20mm longer than the 12a. Good luck Ryan |
Actually its 10mm.I know.I did my 13b into my 83 with the SE K-member. https://www.nopistons.com/forums/pub...#>/biggrin.png
|
It's 10mm on each housing.
|
Originally Posted by moremazda' date='May 30 2003, 12:59 PM
It's 10mm on each housing.
|
thanks guys. My one problem is that when I whent to go look at the car the throttle body and what it's connected to was unbollted from the intake. I fear the someone got to some inportant parts I need to make it run. I'm wondering if my intake off my 12a will fit on the 13b so I can just carberate it and my exhaust.
Do you guys no a place called performance it's a rotary specialist in tulsa. |
Originally Posted by Wanker' date='May 31 2003, 01:56 PM
thanks guys. My one problem is that when I whent to go look at the car the throttle body and what it's connected to was unbollted from the intake. I fear the someone got to some inportant parts I need to make it run. I'm wondering if my intake off my 12a will fit on the 13b so I can just carberate it and my exhaust.
Do you guys no a place called performance it's a rotary specialist in tulsa. |
Originally Posted by Wanker' date='May 31 2003, 01:56 PM
thanks guys. My one problem is that when I whent to go look at the car the throttle body and what it's connected to was unbollted from the intake. I fear the someone got to some inportant parts I need to make it run. I'm wondering if my intake off my 12a will fit on the 13b so I can just carberate it and my exhaust.
Do you guys no a place called performance it's a rotary specialist in tulsa. |
All times are GMT -5. The time now is 09:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands