Rotorfest Preview
06-19-2004, 10:21 PM
#1
Senior Member
Thread Starter
Join Date: Sep 2002
Posts: 1,089
heres the car fresh outta the paint booth, it still needs reassembly, and to touch up the interior where it got some primer overspray from the exterior.
front suspension is now in and the skinnies are on the front. the car will be at rotorfest, but unfortunately wont be running. (no time to finish wireing)
btw this is a 'pro street' car that will see ocasional street duty (in case you guys were wondering about the glass windshield and hatch)
comments welcome
heres some old engine bay shots early in the exaust mani fabrication process
see you guys at rotorfest
front suspension is now in and the skinnies are on the front. the car will be at rotorfest, but unfortunately wont be running. (no time to finish wireing)
btw this is a 'pro street' car that will see ocasional street duty (in case you guys were wondering about the glass windshield and hatch)
comments welcome
heres some old engine bay shots early in the exaust mani fabrication process
see you guys at rotorfest
06-20-2004, 01:03 AM
#2
Senior Member
Join Date: Nov 2002
Location: Orlando, FL
Posts: 563
Looks great- Big *** turbo
Make sure you don't forget to insulate those water injection lines as they go through the firewall. The vibration would end them quick. Too bad you can't get it running for rotorfest- That would be nice to see.
Make sure you don't forget to insulate those water injection lines as they go through the firewall. The vibration would end them quick. Too bad you can't get it running for rotorfest- That would be nice to see.
06-20-2004, 11:19 PM
#3
Senior Member
Thread Starter
Join Date: Sep 2002
Posts: 1,089
Originally Posted by qwester007' date='Jun 19 2004, 10:03 PM
Looks great- Big *** turbo
Make sure you don't forget to insulate those water injection lines as they go through the firewall. The vibration would end them quick. Too bad you can't get it running for rotorfest- That would be nice to see.
Make sure you don't forget to insulate those water injection lines as they go through the firewall. The vibration would end them quick. Too bad you can't get it running for rotorfest- That would be nice to see.
oh and those arent water injection lines, they're going to the 50psi blower gauges. those lines will be changed to steel braided when the real motor goes in, thats just a dummy block we used to make motor mounts, exaust mani, ect..
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)