Hey
I need i think i need some as when i looked at my rear diff the other day when it was on the ramps the whole of the diff and the axels were covered in oil. i've been looking for quite a while but i can't seem to find any anywhere if you can help would be much appreciated.
Thanks
Hello
| Welcome to Nopistons.com, feel free to look around, while you're at it take the time to register. Registered users can add their car, photos and mods to the garage, add your time slips, send PM's, invite friends, make posts and best of all it's FREE! To Register, Click Here and Follow The Instructions | |
| Welcome Guest Messages 5.0.0 © 2010 IBMafia | |
Page 1 of 1
93 Fd Rear Diff Oil Seals
#2
Posted 08 March 2010 - 04:10 PM
When I had an axle shaft seal leak the oil was getting on the shaft and slinging it everywhere, even up to the body above. Housing had a lot of oil on it also. I can't imagine the diff vent coming off and I don't know if any would come out of there if it did but you could check it. It's on the upper rear of the housing. Might as well check the axle shaft boots also. They would sling grease in all directions if one is torn.
#3
Posted 08 March 2010 - 04:18 PM
I didn't understand correctly. You are looking for the seals. I don't know what parts stores you have in your area but you can order from Mazdatrix.
http://www.mazdatrix.com/g7.htm
I'm assuming the diff housing is same. I would think so. If you don't know you could just measure id and od and ask them to compare.
Also, you could measure id and od or just take one of the seals to an industrial supply place and get a general application oil seal if you need one quickly. A place like Motion Industries if you have one near. I don't know if they have UK locations or not.
http://www.mazdatrix.com/g7.htm
I'm assuming the diff housing is same. I would think so. If you don't know you could just measure id and od and ask them to compare.
Also, you could measure id and od or just take one of the seals to an industrial supply place and get a general application oil seal if you need one quickly. A place like Motion Industries if you have one near. I don't know if they have UK locations or not.
This post has been edited by CrimsonPride: 08 March 2010 - 04:26 PM
Share this topic:
Page 1 of 1
Similar Topics
| Topic | Forum | Started By | Stats | Last Post Info | |
|---|---|---|---|---|---|
|
Water Seals? Or Maybe Not--help
|
2nd Generation Specific | loudazzrx7 |
|
|
|
What Size: Stock Apex Seals On The 12a?
|
1st Generation Specific | Mazderati |
|
|
|
Oil Consumption
burning or leaking? |
2nd Generation Specific | Mazdaroti |
|
|
|
after a night at the track... |
2nd Generation Specific | RX7Aggie |
|
|
|
Turbo II
Differences? |
2nd Generation Specific | dac |
|
1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users

Help

View Garage











