Engine Swaps All about engine changeovers,swaps and related issues.

04 rx8 wont start

Old 06-24-2011, 10:09 AM
  #1  
Junior Member
Thread Starter
 
norx8's Avatar
 
Join Date: Jun 2011
Location: essex
Posts: 1
Default

hi i am new and posting this on behalf of a friend who has a 04 plate rx8 that wont start it spins over but wont attempt to fire,someone told her it was coil packs so she had them changed and still wont start,i am looking at it tomorrow and was wondering that if it had a imobiliser would it be connected to the ignition side of the coil to stop it firing.she had a little crash in the front but car was runing fine after that.do these cars have crank sensors or cam sensor,be gentle as im new to rotary engines lol.do the coil packs have to be coded to the key,any info welcome.the car is totally standard.
norx8 is offline  
Old 07-09-2011, 12:28 AM
  #2  
Senior Member
 
thatpoorguy's Avatar
 
Join Date: Nov 2009
Location: peru, IN
Posts: 1,833
Default

First off, welcome to nopistons!! This isn't exactly the right area and I'm no expert by any means but I can tell you what I do know. For starters, there's no cam position sensor because there isn't a cam lol. If you look up wankel rotary engine on wikipedia.org they have a pretty good animated picture of how one runs. Now for the issue.....ignition can cause problems but isn't that common unless a harness has worked itself loose. On the rx-7's (forerunners to the rx-8) have essentially a crank trigger on the front of the engine right by the main pulley. FYI though, a rotary's crank is called an eccentric shaft, or e-shaft for short. What might be causing the no start, and is a very common issue with rotaries, is flooding. Very simple problem to fix, but a pain when it does it when you need to drive right now. Start off by pulling the fuse or relay for the fuel pump. Insert a small amount of trans fluid into the spark plug hole of each rotor (there are two plugs per rotor), pit the old plugs back in, then crank the engine a few times. Don't expect it to start, because there's no fuel going to it, you're just trying to get all the excess fuel out. After you've done all that, replace all 4 plugs with new ones (the old ones typically get fouled out when flooded) and start the car. To prevent flooding again in the future, try to always let the car completely warm up before shutting it off.



Best of luck!
thatpoorguy is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Shieldsr3
2nd Generation Specific
5
12-03-2002 10:20 PM
The Blue Bomber
2nd Generation Specific
19
07-17-2002 04:00 PM
n2audio77
2nd Generation Specific
13
05-26-2002 10:30 AM
n2audio77
2nd Generation Specific
4
05-01-2002 10:24 AM
Squirrel
2nd Generation Specific
3
10-08-2001 07:42 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread
Quick Reply: 04 rx8 wont start



All times are GMT -5. The time now is 01:26 PM.