Problems with fresh rebuild - Wont start
#12
when i flooded mine all the excess fuel over the plugs fouled them out. it wouldn't start again till i deflooded it and swapped the plugs. i spent an entire weekend chasing the ignition system thinking it was that, then i swapped the plugs and it was fine lol. once you get it started, keep it running to make sure it's cleared out all of the excess fuel. otherwise, it'll die and flood again haha
#13
Post Revival! MUHAH! Sorry guys for the lack of reply. Got the rotor motor running, turned out to be an electrical issue. Not sure what though as the thing went after I re-installed a few relays after doing a compression test. Knew the thing would start as soon as I saw stable voltage on the ECU.
Car runs great, blew the single turbo's oil seal though lol thats off for repair.
Car runs great, blew the single turbo's oil seal though lol thats off for repair.
Thread
Thread Starter
Forum
Replies
Last Post
mazdaez7
Rotary Engine Building, Porting & Swaps
9
05-19-2019 07:57 PM
jsnow104
Rotary Engine Building, Porting & Swaps
11
01-03-2011 05:42 PM
RX7 in DAGO
1st Generation Specific
13
08-20-2002 10:16 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)